list208.zip
Listserv 2.08 for WC 4.x. Run multiple 'Net mailing lists.
FILE_ID.DIZ
Listserv v2.08 - lets you run multiple
Internet mailing lists from your Wildcat
v4.x BBS. FREE wcCODE program!
Compiled for Wildcat v4.01
Added the following:
-2.08: Added a filter file to define lines
that can be removed from outgoing
messages on the list. This should
fix a bug where messages were getting
looped back to the mailing list.
-2.07: The 'skip deleted messages' function
added in v2.06 was causing Listserv
to skip every new imported message.
This should now be fixed.
-2.06: Will now skip messages marked as
deleted.
-2.06: Fixed a bug that would start at the
first message if last message pointer
was pointing at a non-existant
message number.
-2.05: Added support for a LISTSERV@
address. You can now send messages
with 'subscribe' and 'unsubscribe'
commands in the body of the message.
Subscription requests can still be
sent in the original fasion as well.
-2.05: Fixed a bug occasionally found when
reaching the end of a subscriber
list.
-2.04: Not released
-2.03: Messages sent from non-subscribers
are skipped and not sent out on the
list
-2.03: Fixed a bug where Listserv would
process one message and then stop
-2.02: Recompiled for Wildcat v4.01
-2.02: Messages with a subject containing
HOST UNKNOWN are now skipped
-2.02: Fixed a bug where Listserv was
sending out messages with a blank
subject
-2.01: Turned off the Pause prompt
-2.01: Messages with a subject of
EXECUTION FAILED or a blank subject
are now skipped
-2.00: Support for multiple mailing lists
-2.00: Custom messages for each maling list
-2.00: Messages with SUB/UNSUB as the
subject are now valid sub/unsub
requests
-2.00: Listutil has been enhanced to support
the new multiple-list version
-2.00: Listserv will change back to the
original conference it was launched
fromFiles inside (4)
| FILE_ID.DIZ | 2 KB |
| LISTSERV.DOC | 13 KB |
| LISTSERV.WCX | 5 KB |
| LISTUTIL.WCX | 5 KB |